Komplet zębatek Torque Up + tłok [AimTop]

Serdecznie nie polecam
Rzekomo mają wytrzymać sprężynę 150
U mnie przy założeniu 130 zorało wszystkie zęby na zębatce tłokowej na styku ze środkową

Tragedia tragedia jeszcze raz tragedia

Haven't actually used this set yet, but I have the same set from Aimtop with high speed gears in one of my replicas for quite a while now. I have it short stroked by 4 teeth and running a Guarder SP 130 spring (eaquals a M150) for woodland games, max 1.7 Joule and a random spring for cqb giving max 1.2 Joule.

Haven't had any issues but byers should know that Aimtop sector gears have an enlarged tapet plate pin, wich have the exact same size as an standard sized tapet pin with the ASG gear delayer chip(wich actually also pulls the tapet plate back a little further). Nice if you are using them in an ASG Scorpion Evo wich can cause feeding issuess not using a tapet delayer chip, especially if you're using the Evo Maxx hop chamber.

They can in some replicas pull the tapet plate a little to far back causing extra stress on the tapet plate(and slowing down the cycle time) forcing the tapet plate to bend to be able to get the tapet fin past the sector gears tapet pin every time it being pulled at maximum.
Haven't tried it with Aimtops tapet plate to see if the fin is a little bit smaller to solve this. If get problems becuase of this you can trim down the tapet plate until it no longer needs to bend to get past the tapet pin.