[Zestaw] SR9A3 (Dual Powered GAS/CO2) - Black [SRC] + Kabura Airsoftowa do Beretta M9/92F - Black [Amomax]

Kabura beznadziejna moja beretta m92f ledwo wchodzi a jak juz wejdzie to 2 osoby muszą ją wyjmować. Materiał jest słaby i nieodporny na temperatury kabura ogółem jest słaba i się ugina pod naciskiem. Produktu nie polecam

Kabura bardzo przyzwoita. Moja Beretta M-9 dobrze pasuje choć ma jakieś niewielkie luzy (w górę i w dół) ,ale za te pieniądze to naprawdę godna polecenia. Na strzelnicy przetestowana i uważam ,że sprawdziła się na 100%. Nie mogę się do niczego więcej doczepić. Ja osobiście polecam tą kaburę.

Kupiłem ta kaburę i niestety nie nadawała się do mojej repliki. Na ogół ładnie wykonany wygląda na solidne. Fajne jest odbezpieczanie gdyż wygląda na funkcjonalne. Mimo że nie korzystałem wygląda na ok produkt

Kupiłem do Beretty M9 KJW była za ciasna, ale po podgrzaniu kabury i wystudzeniu, z repliką oklejoną taśmą klejącą w środku, pasuje perfekcyjnie. Trzyma pewnie bez zbędnego luzu. Polecam zakupić od razu z dedykowaną platformą biodrową, znacznie poprawia funkcjonalność kabury umożliwiając regulację wysokości zawieszenia repliki.

Kupiona wraz z replika jako zestawił. Replika siedzi twardo i pewnie.sama kabura sprawia wrażenie solidnej i mocnej,także nic tylko strzelać i strzelać . W dalekich planach mam zamiar nieco ja przemalować by nadać indywidualnego wyglądu.

Dobra kabura wykonana z solidnego materiału. Prosto po wyjęciu z opakowania replika M9A1 USMC [WE] bardzo ciasno siedzi, ale uważam, że z czasem się wyrobi. Gorące powietrze też podobno pomaga. Polecam

Kabura wykonana porządnie i z dobrych materiałów. Noszę w niej Berettę od STTI i replika siedzi w niej ciasno i bez żadnych luzów. Zatrzask dobrze zabezpiecza replikę przed wypadnięciem z kabury. Kaburę można zamontować do płetwy, platformy udowej, panelu biodrowego, adaptera MOLLE oraz adaptera do pasa. Sama płetwa też jest dobrej jakości i wykonana jest z porządnych materiałów, kaburę można na niej regulować w zakresie 360 stopni. Według mnie jest to jedna z najlepszych twardych kabur dostępnych na rynku

Kaburka fajna, dobrze wykona do berrety pasuje idealnie. Przycisk blokady działa bez zarzutu nie lata nie ma luzów dobrze się ją ustawia trzyma dobrze się pasa a pistolet nie ma szans żeby wypadł. Nie jest też bardzo duża więc nie ogranicza ruchu podczas wyciągania.

Metalowy, Wygląda na Solidnie wykonany.
Fps w granicy 1J na zielonym gazie, choć na razie jest zimno. Wyraźnie widać kiedy jest mało gazu lub Gaz jest zimny.

Polecił bym to dla każdego co by chał Brertta M9.

Świetna replika do strzelanie, dobrze leży w dłoni i dobrze się z niej celuje, dolne szyny ris są bardzo przydatne, trzeba tylko założyć latarkę z laserem i replika staje się dosłownym królem CQB (przynajmniej w mojej sytuacji)

Mógłbym zachwalać jaka ta kabura jest dobra i że nie da się bez niej normalnie grać i coś w tym jest bo w porównaniu z zwykłą uniwersalną kabura to jest ogromna różnica. Podczas biegu replika nie telepie się na prawo i lewo i po strzelance nie musisz szukać gdzie ci wypadła. Możliwość regulowania kąta pod jakim replika siedzi w kaburze daje możliwość wyregulowania sobie wszystkiego pod siebie co ułatwi szybkie dobycie pistoletu i sprawne zrobienie fraga.

I know the Glock already so I decided to look for another GBB pistol. And then I saw the Beretta M9 with its elegant and still tough looking design. Well.. happy I bought this one with a nice greengas blowback action and accurate out of the box. Real joy to use this in a game.

Unbeatable price for a very good quality holster, the material is a very well cast plastic. M92F or M9 Military GBB, plastic or metalbody fits very well and has a nice firm lock. Very useful for gaming gear when you need to quick draw the side gun with only one click release. I mainly use the over-belt fit instead of in-belt because the anti slip design does the job very well

Here is my second review of using the replica after 3 months (both in the garden and airsoftfield)

Short review:
-----------------
+easy to use
+it has pistol case
+very close to M9A3
+you can add trasers and flashlight
+balanced and easy to insert mags
+cqb and decent sidearm
=trigger is easy pull
=it lacks Decocker
=not a quick firing gun
=no full original markings
-no reddot mount, you need to get aftermarket one
-some mags (C02 my case) may be defective

My rate 8/10, is decent and simple


Looong review:
------------------
Unboxing:
-in the box- no wait this time it comes in a pistol case, you get the pistol, a green gas magazine and a manual.
-the manual may be for full automatic version instead of semi only, unless I missed something.. other than that is the same way to use it.
-the pistol case is pretty decent, you can even fit a WE-tech Desert eagle with ease, I once put a WE-tech 1911 with 4 magazines (not inserted) and it still hold them well.
-one problem with the case is the foam is lose, you can use double tape or glue and it should be fine.

First looks:
-looks and feel good in hand, full metal except the grips and the sights, around 1kg and balanced (with mag).
-pretty close to the real deal, the M9A3, only minus the Markings, you only get the number id. Other than that, is really great.

Test fire:
-it uses a Green Gas or C02 mags (as long is for this model), inserting the mag is very smooth and easy, it is secured well and wouldn't fall, just be gentle when you insert it, nothing to worry tho.
-running the slide to load it isn't too hard, unless you pull it slow then it will go hard, but I nitpicking here..
-you got double action or single action, single action when the hammer is pulled and double if you never pulled (hammer down), I will talk more about it on "Safety".
-single action is soft but kind of long than it should be, not for long range aiming I'm afraid..
-double action is very long (again double action..), but very light, you can pull the trigger without pulling the slide but you wouldn't shot anything but after, more on "Safety".
-pretty soft shooting, not too hard just perfect (that is if you use green gas), pretty good as an easy to use sidearm.

Safety:
-the safety switch disconnects the trigger, can be activated both cocked or uncocked.
-the switch does NOT decock the hammer like the real deal sadly, this may come as a good or bad thing for you.
-if you want to be 100% safe when carrying the pistol, I recommand to no pull the slide and the hammer, and have it as double action, first shot will be empty but next will be shooting bbs.
-the safety switch is a bit hard to use it, there is a method on how to pull it to fire by just brushing your right hand thumb forward towards the barrel (better watch a video to understand what I mean).

Magazine:
-while it can run both Green Gas and C02, I could only run the Green Gas one, since the C02 was defect, both run I think 20 bbs.
-the mag goes well in nothing to complain, you can do the tactical reload with ease, they have large buttplates made out of plastic that don't bite your hand when you load it.
-it can hold about 2 fully loaded magazines, that is if you don't bumpfire the trigger..

Technical part:
-shots around 1 joule with 0.20g bb, it can be used in cqb with no problem, if you insist on accuracy you could try 0.25g.
-the hopup can be adjustated iffffff you pull the slide out and rotate the wheel.
-disassembly is easy, first remove the mag, pull the hammer (you need to so you are able to put the slide back), press the button on the right side of the pistol in the middle, and pull the lever down from the left side of the pistol in the middle, the slide comes out and can be pulled out, you will have to pull the barrel a bit forward and up in order to remove the spring guide and then you can remove the barrel for full clearing (note: you will need to remove the adapter in order to take it out).
-you can add a tracer or a suppressor on it, altho weight may jam or waste bbs so.. use something not too heavy.
-no reddot mount, unless you go for rear sight mount or rails from below mount to use a reddot.

3 Months of use:
-not a year like the Kar98 but still enough to get an idea of it. So far no jams or anything that requires me to use a hammer.. again..
-tried when it was much colder, the closest I got was 2°C but it still ran with no issue, the slide get locked no matter what.
-you can defently spam the trigger like a maniac but it wouldn't be very fast, it does its job if you enter panic mode when it comes to reach for your pistol because you forgot to load your primary, ye I got shot by a lmg guy...
-the sights are okey, you may need to use sandpaper to make them smooth, mine has a bit of "hair" on it.

Finall thoughts:
-if you look for something that isn't Hi-capa and easy to use, this would do it, just don't expect to use it as a sniper, unless you are good/lucky to hit.

I rate it 8/10

Fits the LS Beretta more or less perfectly. I had to use some silicone oil to ease the fit somewhat, but now it's perfect. Very satisfying clicking sound when the gun locks in place. It seems to keep the gun perfectly secured.

Hello!
Maybe I should have looked around a little more on the subject. Unfortunately, the holster does not fit my Sti non-blow back pistol. It took a bit of sanding and carving to make it work as it should. The material is very strong and durable, but the gun does not go in until it clicks. It had to be shaped both at the case and at the saddle. It might fit a different type of Beretta.

Great holster for the price. Plastic is extremely tough
and hard. Lock mechanism works flawlessly. Belt buckle/attachment point is also super durable.
Does not flex or bend where it does not need to.

Fit is tight and without wobble for most M9 models.
10/10

Excellent product. The construction of the gun is al metal and with an extremely good finish.
Build tolerances are really good.
No barrel wobble when the slide is in battery, trigger pull is as it should be in double and single stage.
Hop up is also good.
Accuracy is great for a sidearm out of the box.
Magazines has a steel nozzle so no leaks.
10/10

Got this one to fit my KJW M9 and it fits like a charm .You can attach it to your belt ,vest, leg holster with the appropriate mounting .

Reasonable pricing and from my experience ...robust
i m having mine for 6 years and it only have scratches on it not even a slight crack .

Hi!
The product is very good! The Beretta fits perfectly. Quick release works precisely. It looks solid. As usual, everything arrived unopened and undamaged. It also comes with an Allen key! I recommend!!

Solid pistol with good accuracy, with CO2 that is. Don't know if it's just my copy of the gun, but it lets out too much gas when using green gas magazines. Can't get through a full mag without it farting, miss-feeding and not cocking successfully after shooting. Keep in mind, this is in 18°C weather. Shouldn't be affected by that temperature. I maintain it properly as well. With CO2, it has no issues. But then it reaches 1.6J with 0.2's. Going way outside my sites legal CQB legal range, so it's only legal at minimum 15m. Making it pointless as a secondary.

I have contacted TG about this and they were to no help

Very good product highly recommend
You should buy from Taiwangun since they have the best products on the market at affordable prices! Bought many products from them for me and my friends and we never got disappointed once :)

I bought this to practice at home and to sometimes participate in games. It is exactly what I was expecting. Comfortable, easy to operate and also accurate. Not the cheapest piece, but is worth the price for sure. One of my best choices.

Beretta M9/92F Airsoft Holster Series - Black [Amomax]
It's a good case, that encsases and protects the gun.
Quick to use and it can be paired with any belt you want.
With the correct attachment, it can also go to molle.

The BERETTA M9/92F AIRSOFT HOLSTER SERIES - black [AMOMAX] it is very good quality and value for money. The color is black and it is very good plastic. It is easy to use and more comfortable. Nothing wrong with this product. It is what to expect it. Taiwangun is excellent.

The BERETTA M9/92F AIRSOFT HOLSTER SERIES - black [AMOMAX] it is very good quality and value for money. The color is black and it is very good plastic. It is easy to use and more comfortable. Nothing wrong with this product. It is what to expect it. Taiwangun is excellent.

I use this pistol holder with a KJW M9 Co2 to keep it from falling out of it.
The material is perfect to use, minimally flexible but durable.
The Beretta will not be lost.
the color is different from my uniform, but that’s my own problem.
It could be in several colors.

The best pistol I ever seen on airsoft. CO2 mag , 480 fps with 0.20 bbs. Amazing..... shoot and hit a target on 70m range.No problems with jams for now. Marks on sights fell down from to much power but that was expected. co2 Magazines are expensive but works perfect. Lips are strong and working for now but we will see.Changing inner barrel to 6.01 I got more accurate fly of bb on longer range so it is recomended to do the switch. Replica is made full of metal that is good, feel great in hands. 5 star from me.